1. Vehicle VIN plates match, engine compartment, door jambs and dash
2. VIN/FMVSS label on door jamb
3. Perform VIN status check, perform applicable recall or campaign repairs
UNIBODY INSPECTION
4. Carefully inspect unibody for signs of damage or prior repairs
MECHANICAL INSPECTION MINIMUM REPLACEMENT ITEMS5. Engine oil and filter (with genuine Honda filter)
6. Air filter (if dirty or at service interval)
7. Brake fluid (if discolored or at service interval)
8. Floor mats (replace mats, unless current model)
9. Wiper blades (replace if needed)
10. Coolant (replace if discolored or at service interval with genuine Honda fluid)
11. Tires (minimum tread depth 5/32 across tread width)
12. Disc brake pads (if wear is greater than 50%)
13. Brake shoes (if wear is greater than 50%)
14. Antenna mast (if bent or sticking, if applicable)
15. Automatic transmission fluid (if discolored or at service interval)
16. Differential fluid (if discolored or at service interval, if equipped)
17. Rear differential fluid (VTM) (if discolored or at service interval, if equipped)
18. Minimum two master keys, one valet and two remotes (if equipped with OEM remotes)
19. Scheduled Maintenance - Nearest scheduled maintenance must be performed if within 3 months or 2500 miles of service interval or if no record of service exists
ROAD TEST20. Starting/ Starter (cold/hot)
21. Idle vibration (cold/hot)
22. Engine noise (cold/hot & high/low speeds)
23. Acceleration (power)
24. Engine operating temperature
25. Driveability (smoothness)
26. AT shift quality/AT shift points
27. MT shifter operation
28. MT clutch (smoothness, effort, slippage)
29. Transmission/transaxle noise (cold/hot)
30. CV joint/drive axle noise (full lock turn)
31. Braking (noise, vibration, effort)
32. Parking brake operation
33. Steering effort (drifting right or left)
34. Steering wheel free play/steering wheel centered
35. Cruise control operation (Including resume)
36. Horn operation
37. Wind noise/squeaks/rattles
38. Speedometer/odometer operation
39. Heater/defroster operation
40. A/C cooling performance/vent outlet temperature
41. Tire or steering wheel vibration
42. Body/Suspension (Performance/Noise/Rough Road test)
UNDERHOOD - CHECK FOR UNACCEPTABLE
AFTERMARKET MODIFICATIONS43. Battery (condition, Fluid level, Load Test
44. Alternator (belt condition/tension, charging)
45. Water pump (noise / leaks)
46. Distributor (cap & rotor condition, shaft looseness)
47. Ignition system operation
48. Fuel system operation (connections/leakage)
49. Fuel filter (replace per maintenance schedule)
50. Radiator (leaks, road hazard damage)
51. Coolant recovery tank (condition, fluid level, sensor operation)
52. A/C condenser (corrosion, road hazard damage)
53. Cooling fan operation
54. Coolant (replace if discolored, insufficient protection)
55. Coolant hoses (check condition)
56. Power steering (fluid level, belt condition/tension)
57. AC compressor (proper cycling, belt condition/tension)
58. Heater valve adjustment
59. Engine Valve noise
60. Engine/Transmission mount condition
61. Engine condition (visual verification of oil change maintenance)
62. Timing belt condition (change per maintenance schedule)
63. Brake master cylinder and booster (operation/leaks)